SpoolEase Duo Components
warning
SpoolEase Duo is a new build, so these instructions may contain inaccuracies. Please read them carefully, and if anything is unclear, ask on GitHub or Discord.
IMPORTANT: For now, setup requires instructions that will be provided through Discord. This will remain until the installation process is stabilized.
- WT32-SC01 Plus (make sure to pick the board and not accessories)
- 7-wire cable with JST 1.25mm connector for the HX711 (one normally comes in the box with the WT32-SC01 Plus)
- 8-wire cable with JST 1.25mm connector for the PN532 (make sure to pick the 1.25mm connector size and 8 pins)
- PN532 NFC reader module (make sure to pick the module and not accessories)
- HX711 AD Module + LoadCell
Select a LoadCell based on the heaviest spool you plan to measure. Typical 1kg spools usually weigh around 1.25kg. Choose a 2-5kg capacity load cell for optimal accuracy. SpoolEase Scale has been tested with 2kg and 3kg load cells. - microSD Card – FAT-formatted (classic 8.3 filenames; can be formatted directly on Bambulab printers)
- Printed 3D model parts for the SpoolEase Duo case - [https://makerworld.com/en/models/3598420]
- Optional, use only if needed - four M2x10 screws to securely hold the display in place, be careful not to over-tight which could break the display
- 2x M5x30 socket head screws for the load cell
- M4x20 screws for the curved top plate
- Zip ties for securing the wires
- Soldering tools
Optional but Recommended
- For attaching tags to spools with ID and Material: 3D Model of SpoolEase Spool NFC Tag Holder with replaceable material and ID - https://makerworld.com/en/models/2050083